1
$\begingroup$

When I select the entire edge suddenly the selection stop in that point as show in the picture.

Cant figure why!!! What I can do?

There's no ngon, no double faces, no double vertex......

Thanks for any help.

enter image description here enter image description here

Improve this question
$\endgroup$
3
  • $\begingroup$ did u try fixing the normals? $\endgroup$
    – Chris
    Commented Nov 18, 2023 at 5:07
  • $\begingroup$ Edge is selected if participates in a "4-way cross road". the selection continues by picking the edge with smallest edge angle to the previous one (like a car crossing straight ahead". In you case the edge comes to a 3-way cross-road and that is why the selections stops there (it could go equally in any direction, not just the one you think about). It always has to be a 4-way connection. $\endgroup$
    – Rumen Belev
    Commented Nov 18, 2023 at 10:03
  • $\begingroup$ oh thanks a lot! $\endgroup$
    – Lovera
    Commented Nov 18, 2023 at 22:49

1 Answer 1

Reset to default
1
$\begingroup$

It meets a pole here, it doesn't know which edge it is supposed to select next:

enter image description here

Improve this answer
$\endgroup$
1
  • $\begingroup$ thank you so much! $\endgroup$
    – Lovera
    Commented Nov 18, 2023 at 22:49

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .