2
$\begingroup$

I want to put this face on a sphere in a way where it can be animated, I know the topology needs to be clean for animation, do I need to retopo the whole sphere around the face, or is there a better way to go about that? Im also not sure the edge flow is correct.

enter image description here

enter image description here

enter image description here

Improve this question
$\endgroup$
1

1 Answer 1

Reset to default
1
$\begingroup$

The edge flow seems correct, now you could rotate your sphere 90° on X so that the pole is under your face. Once you've applied the Shrinkwrap, extrude all the outline of the mesh, make it circular, cut a hole in the sphere, join the face with the sphere.

Your current mesh, shrinkwrap it on the sphere:

enter image description here

Extrude its outline:

enter image description here

Apply the Shrinkwrap, join with the sphere, cut a hole in the sphere, bridge the 2 meshes:

enter image description here

Here is what it should give:

enter image description here

Improve this answer
$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .