1
$\begingroup$

ModifiersMesh selection issue

Hi All,

There is probably a very simple answer to this. However when I enter edit mode I am unable to select my who mesh, only the ring of faces as shown below.

What am I doing wrong.

Cheers Aaron.

Improve this question
$\endgroup$
6
  • $\begingroup$ Could you post image with Modifiers tab selected? It's probably because this mesh is generated by some of them (modifiers). $\endgroup$
    – cgslav
    Commented Sep 11, 2017 at 23:15
  • $\begingroup$ Hi LukeD, Please see attached, The only modifier I have active is a mirror. $\endgroup$
    – Aaron W
    Commented Sep 12, 2017 at 0:05
  • $\begingroup$ Well... Could you please upload blend file with this object to: blend-exchange.giantcowfilms.com I'll check it. $\endgroup$
    – cgslav
    Commented Sep 12, 2017 at 0:08
  • 1
    $\begingroup$ You are in Face select mode but I don't see any faces on your model except for the ones in the highlighted ring. What happens when you go to Vertex Select mode? What does the model look like with Solid Shading enabled instead of Wireframe? $\endgroup$
    – bertmoog
    Commented Sep 12, 2017 at 3:04
  • $\begingroup$ I think you have hidden most of your mesh - Alt-H - to unhide it. $\endgroup$
    – sambler
    Commented Sep 12, 2017 at 6:39

1 Answer 1

Reset to default
1
$\begingroup$

It was a simple problem. Other faces of the mesh were hidden.

The answer was to unhide them with Alt + H in Edit mode

Improve this answer
$\endgroup$

Not the answer you're looking for? Browse other questions tagged .