3
$\begingroup$

I am attempting to create an arena using the Archimesh addon and the curve modifier. I created a set of archways and columns with Archimesh, using the built in "create an array of elements" checkbox. I then set the Fit Type of the array modifier on the created objects to "Fit Curve", then add a curve modifier set to a bezier circle using the default settings.

My problem is that the start and end points of the object arrays overlap. Endpoints of arrayed object overlap

Any help fixing this would be greatly appreciated.

Improve this question
$\endgroup$
3
  • $\begingroup$ You need to make the circle bigger or the pieces smaller - there is no other way.You make the circle bigger by scaling it edit mode.You make the arrayed piece smaller also by scaling it in edit mode. $\endgroup$
    – Jaroslav Jerryno Novotny
    Commented Sep 27, 2016 at 16:27
  • 1
    $\begingroup$ If the curve is circular, using the 'bend' option of the 'simple deform' modifier can be an alternative $\endgroup$
    – lemon
    Commented Sep 28, 2016 at 8:48
  • $\begingroup$ if using relative offset, you can manually find an offset value that makes all pieces to fit the curve, even if they are no more connected. Eg, instead of offset 1, you could find that 1.0175 would make a good fit of the curve. Then, scale your object of that exact amount along the local axis used to fit the curve, and then reset the array offset back to 1. It may fit perfectly. $\endgroup$
    – m.ardito
    Commented Sep 28, 2016 at 11:58

0

Reset to default

You must log in to answer this question.

Browse other questions tagged .