Image of what I'm talking about:
I can't figure out how I can make holes in that pages where each ring is attached there in several pages beside it like 15-20. How can I cut holes there?
$\begingroup$
$\endgroup$
3
-
$\begingroup$ Do you need it to be low poly? $\endgroup$– cgslavCommented Jun 17, 2017 at 14:41
-
$\begingroup$ @LukeD no i m trying to making realastic render $\endgroup$– KartikCommented Jun 17, 2017 at 14:43
-
2$\begingroup$ Instead of many holes, do just one section with one hole, and use an array modifier to complete the page, for the rings you can also use an array. $\endgroup$– user1853Commented Jun 17, 2017 at 15:26
Add a comment
|
1 Answer
$\begingroup$
$\endgroup$
Final:
Simplest way with quad topology would be to cut holes in Subdivided Plane and add Subdivision Surface modifier.
Steps:
- Create a Plane.
- Go to Edit Mode and Subdivide it twice. First time with 10 cuts, second one with 1. You can go further if you need different hole placement.
- Select faces where you want your holes and delete them.
- Remove unnecessary faces to trim page as you want.
- Select outer edge of the mesh and add to it Mean Crease > 1. This will ensure that corners stay sharp after Subdivision Surface modifier will be added.
- Add Subdivision Surface modifier. I've set it to 2.
Final touches:
If you want smaller holes you can select Edge Loop around them in Edge Select mode, switch to Pivot Center > Individual Origins, then Extrude and Scale them down.