0
$\begingroup$

Good morning, I'm trying to make two square holes in a cube. I managed to make the first one: enter image description here

But when it's time to do the second one, the software can't take the sides of the cube anymore since the cube has been transformed, I can't select the top side but only certain side of the lines, so if I try it gives me something like that:

enter image description here

May I know how to make two holes? Thanks.

Improve this question
$\endgroup$
1
  • $\begingroup$ You should use Boolean modifier $\endgroup$
    – cxnt
    Commented Feb 26, 2020 at 13:41

2 Answers 2

Reset to default
1
$\begingroup$

What steps exactly are you taking for this process? Could I suggest using The Boolean modifier? If you don't want to use that you could always use the knife tool or CTRL+R to create edge loops.

Improve this answer
$\endgroup$
0
$\begingroup$

Also you can use Knife Project with the Cut through enabled. It gives you two faces on the opposite sides. You remove the faces and use Bridge edge loops.

Improve this answer
$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .