3
$\begingroup$

turbo compressor housing

tried torus but I'm unable to achieve these fused results and just how to make it small as it goes down?

Improve this question
$\endgroup$
2
  • $\begingroup$ start from a cylinder, you add a bend modifier, and a curve to which the cylinder is bound by using ctrl+p >> follow-curve. $\endgroup$
    – Yvain
    Commented Jun 22, 2020 at 18:22
  • $\begingroup$ thanks a lot, it added a lost basic knowledge into my skill $\endgroup$
    – jd singh
    Commented Jun 22, 2020 at 18:59

1 Answer 1

Reset to default
4
$\begingroup$

Enable the add extra curves addon.

enter image description here

Then add a curve->Spirals->Archemedian

enter image description here

Give the spiral some height

enter image description here

In the geometry section. give it some bevel depth

enter image description here

Then you can edit the radius of one of the end segments to make is smaller

enter image description here

For further editing convert from curve to mesh

enter image description here

Improve this answer
$\endgroup$
1
  • $\begingroup$ thank you very much $\endgroup$
    – jd singh
    Commented Jun 22, 2020 at 19:00

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .