3
$\begingroup$

turbo compressor housing

tried torus but I'm unable to achieve these fused results and just how to make it small as it goes down?

$\endgroup$
  • $\begingroup$ start from a cylinder, you add a bend modifier, and a curve to which the cylinder is bound by using ctrl+p >> follow-curve. $\endgroup$ – Yvain Jun 22 at 18:22
  • $\begingroup$ thanks a lot, it added a lost basic knowledge into my skill $\endgroup$ – jd singh Jun 22 at 18:59
4
$\begingroup$

Enable the add extra curves addon.

enter image description here

Then add a curve->Spirals->Archemedian

enter image description here

Give the spiral some height

enter image description here

In the geometry section. give it some bevel depth

enter image description here

Then you can edit the radius of one of the end segments to make is smaller

enter image description here

For further editing convert from curve to mesh

enter image description here

| improve this answer | |
$\endgroup$
  • $\begingroup$ thank you very much $\endgroup$ – jd singh Jun 22 at 19:00

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.