1
$\begingroup$

Juice spout pouch

Blender noob here! Just started learning how to use blender a week ago and I am having troubles creating a mesh of a juice spout pouch with the left, top and right sides sealed, I did one using a plane and mirroring and extruding the edges, but the mesh is a mess and I cant create the bottom of the pouch so it is just a hole.

What I have:

Mesh 1

Hole at bottom

Sides

The edges are actually a big mess because I used a plane and mirror, then extrude it, so there's some volume, but the sides are supposed to be sealed together and thus have no discernable volume (I hope this makes sense). It looks somewhat fine from top down camera angle but I want to know how to actually model this correctly :/ I also attached 2 images of meshes that I am trying to achieve! It's from a model on cgtrader, I can't figure out how to achieve that. Thank you so much for the help! *TLDR: Is there a better way to model this than plane > mirror > extrude edges? Can't seem to get that bulgy rectangle in the middle with flat, sealed edges at the sides.

What I want:

CGTrader Rectangle Spout Pouch Mesh CGTrader Rounded Edge Spout Pouch Mesh

Bottom of pouch

$\endgroup$
0
$\begingroup$

You can select the bottom edge loop by going in Edit Mode with Tab, and choose the edge select mode.

Then select an edge from the bottom while holding down the Alt key, and press F to fill your bottom.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.