0
$\begingroup$

I'm trying to mode the selected edge so that it's aligned with the vertex below. As you can see all the similar edges are uneven, made with the knife tool.

If I hold the red arrow on the gizmo I can snap to the vertex but it would ruin my angled plane at the top of the bridge.

Does anyone know how to do this? Thank you so much!

aligning the edges to the half cylinder

Improve this question
$\endgroup$
0

1 Answer 1

Reset to default
1
$\begingroup$

You can keep using the knife tool then align the edge after, using "edge slide".

Edge slide is a way to grab along edges and is obtained by typing G twice.

So here:

  • make the cut
  • select the edge and use GG (double keys does not appears on the cast in the gif below) to align to the edge on the right.
  • then GG again to place it where you want, but this time the edge is parallel to the one on the right

enter image description here

Improve this answer
$\endgroup$
1
  • $\begingroup$ Hi, thanks for your response! Although I know the GG function and even when i use it, it doesn't help me. On your example you're snapping to straight edges (edges that align with one of the 3 axes, not sure what the right term is) - in which case GG works well, but I want to snap to an edge but keep my slope/decline. $\endgroup$
    – Dulcis
    Commented Jul 18, 2019 at 15:23

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .