3
$\begingroup$

I tried to use bridge edge loops to connect two faces into the arch, but it behave quite weirdly. Could you suggest how can I fix it?

Thanks, Robertenter image description here

enter image description here

$\endgroup$
6
$\begingroup$

Just increase the Number of Cuts parameter in the operator settings panel (F6), and adjust the Smoothness value to a desired outcome.

enter image description here

$\endgroup$
4
  • $\begingroup$ Can the same system also work in terms of '' lines '' and not edges? $\endgroup$
    – Albizz
    Nov 20 '20 at 20:53
  • $\begingroup$ Not sure I dunderstand what you mean by "lines" $\endgroup$ Nov 21 '20 at 2:28
  • $\begingroup$ From a point, a vertex, in 2D e not in edges $\endgroup$
    – Albizz
    Nov 21 '20 at 2:33
  • 1
    $\begingroup$ No I don't think that's possible, there are no faces to take normals from, so no arch direction can be determined $\endgroup$ Nov 21 '20 at 3:49
1
$\begingroup$

It looks like if you use the W > Bridge Edge Loops, you need to tilt your faces a bit. If you use the W > LoopTools > Bridge (LoopTools addon), you don't need though.

enter image description here

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.