3
$\begingroup$

I tried to use bridge edge loops to connect two faces into the arch, but it behave quite weirdly. Could you suggest how can I fix it?

Thanks, Robertenter image description here

enter image description here

$\endgroup$

2 Answers 2

6
$\begingroup$

Just increase the Number of Cuts parameter in the operator settings panel (F6), and adjust the Smoothness value to a desired outcome.

enter image description here

$\endgroup$
4
  • $\begingroup$ Can the same system also work in terms of '' lines '' and not edges? $\endgroup$
    – Albizz
    Nov 20, 2020 at 20:53
  • $\begingroup$ Not sure I dunderstand what you mean by "lines" $\endgroup$ Nov 21, 2020 at 2:28
  • $\begingroup$ From a point, a vertex, in 2D e not in edges $\endgroup$
    – Albizz
    Nov 21, 2020 at 2:33
  • 1
    $\begingroup$ No I don't think that's possible, there are no faces to take normals from, so no arch direction can be determined $\endgroup$ Nov 21, 2020 at 3:49
1
$\begingroup$

It looks like if you use the W > Bridge Edge Loops, you need to tilt your faces a bit. If you use the W > LoopTools > Bridge (LoopTools addon), you don't need though.

enter image description here

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .