1
$\begingroup$

This question already has an answer here:

I am trying to connect 2 separate paths somewhere along its centre, see picture:

enter image description here

Is there a way to do this?

$\endgroup$

marked as duplicate by cegaton, batFINGER, Mr Zak, cgslav, Shady Puck Nov 11 '17 at 22:58

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

-1
$\begingroup$

Select the points you want to connect and press "F".

$\endgroup$
  • $\begingroup$ I already tried that, it says: "cannot create segment" $\endgroup$ – J. Point Nov 11 '17 at 16:37
  • $\begingroup$ Do you need to create your stuff with a curve? Otherwise convert the curve with alt-c to mesh, then press f to connect the two points and use a Skin- and Subdivisionsurface Modifier on it $\endgroup$ – Quacksilber Nov 11 '17 at 16:50
  • $\begingroup$ I need a connecting cylinder, selecting 2 points after converting it to a mesh will simply make an edge, I can't make this edge a cylinder while remaining merged correctly with the meshes of both paths. $\endgroup$ – J. Point Nov 11 '17 at 17:50
-2
$\begingroup$

If i understood your question you want to join to verts

Go to edit mode ->

Select the 2 verts and Press Alt+C

enter image description here

$\endgroup$
  • 1
    $\begingroup$ Alt + C will not connect two spline points. It will close the spline(s) that selected points belong to regardless of which points are selected. $\endgroup$ – Omar Emara Nov 11 '17 at 17:29
  • $\begingroup$ Like Omar said, this doesn't work, it connect both ends, I am trying to connect a point along its centre. $\endgroup$ – J. Point Nov 11 '17 at 17:46
  • $\begingroup$ @J.Point attach your file $\endgroup$ – atek Nov 12 '17 at 2:14
  • 1
    $\begingroup$ You cannot fork a curve object, you can only float disconnected verts close to each other then make a large bevel size to hide the gap. $\endgroup$ – 3pointedit Nov 12 '17 at 4:09

Not the answer you're looking for? Browse other questions tagged or ask your own question.