0
$\begingroup$

After applying a boolean modifier there is no surface on the area that was carved by the cylinder. It's kind of hard to explain in words. I have a before and after picture. In the after you can see there is no surface on the first part of the hole that was created. Wondering what is causing this...

before Before

after After

$\endgroup$
0
$\begingroup$

you could try the following: Go into edit mode, press a to select all, then w and remove doubles now back into edit mode, press ctrl+a and apply the rotation and scale. now try the boolean modifier again

are there any other things in your modifier stack ?

$\endgroup$
  • $\begingroup$ As always with booleans, check doubles, duplicated geometry, negative scale, unapplied transforms, recalculate normals and if possible avoid ngons. Did I mention them all...? $\endgroup$ – m.ardito Oct 30 '17 at 17:42

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.