# Create a circle from a plane

So new to blender if this is super easy my bad.

I have created a plane with lots of small holes in it to replicate the mesh on the front of a speaker by subdividing a plane and using the Wireframe and Subdivision Modifiers. Creating this I want a circle shape not a square though how can I get the above image to be on a flat circle rather than a flat square to be like this but with my first pictures design not the hex pattern

I hope this edit cleared it up a bit

• Could you please be more specific or describe it in another way? I'm not sure what you want to do. – Reaper Jul 20 '17 at 12:59
• If you started with a square and then your first modifier is a subdivision, it should be round already. So why cut a circle out of it? – Bo Frederiksen Jul 20 '17 at 13:11
• My first instinct was to intersect your mesh with a cylinder using the Boolean modifier, but it seems that the topology is too complicated for the modifier to compute correctly. Even when I applied the wireframe and subsurface modifiers added polygons to the edges to turn the mesh into a manifold: the boolean operator malfunctions. – Mutant Bob Jul 20 '17 at 14:57
• It is clear from the answers given that your question is open to different interpretations. Can you please edit the text and clarify what you want to do? If you have an image illustrating the desired result it would help a lot. – user1853 Jul 20 '17 at 17:43
• related link: blender.stackexchange.com/questions/58811/… – user1853 Jul 21 '17 at 0:47

I used a hexagonal torus with two array modifiers to create the mesh then I just used the Boolean modifier to cut it out. It's dirty but quick and easy:

Use Circle Select to select the extremities and proportional editing to slope the curve downward:

Finally, I added a "rubber" grommet around the edge:

• Ok I thought boolean could only be used to remove a hole from the mesh not take a peice of it thanks man – Brent Clifford Jul 20 '17 at 21:53
• Hey no problem. The Boolean mod actually has three different operations. – bertmoog Jul 20 '17 at 22:07
• Whats the third if you don't mind me asking here – Brent Clifford Jul 20 '17 at 22:12
• No not at all, but it would be more beneficial for you to see it work: youtu.be/pcUe-ab_jQs?t=54 – bertmoog Jul 20 '17 at 22:39
• Cheers mate very helpful – Brent Clifford Jul 21 '17 at 0:41

In the top ortho mode

Take a plane sub divide to 15

rotate in x axis

move little in y axis

Type warp in space bar

and get this settings 180,0,-1,1

Now rotate in y axis

type warp in space bar

and get this settings 360,0,-1,1

Now you get a perfect sphere