3
$\begingroup$

I would like to add an edge loop around each one of these windows and are not 100% sure on the best way to do it even after watching some videos.

If someone could point me in the right direction that would be great. Thanks.

enter image description here

$\endgroup$
1

2 Answers 2

5
$\begingroup$

Avoid NGons, and avoid Boolean operations, you topology is not quad-dominant and you wont be able to easily add edgeloops anywhere with ngons like those around the windows. in fact you will likely have a hard time doing anything at all with your current model.

Ideally your mesh should be made primarily of faces with four sides, use Ctrl+R to add edge loops, use Ctrl+B to bevel, use E to extrude, and abuse of modifiers.

In your case I am guessing a Mirror modifier would help with symmetry, a Subdivision Surface would help with smoothing/curving, and an array might help with multiple windows.

enter image description here

$\endgroup$
1
$\begingroup$

you can select the faces and just use I to inset the selection, this will add loops to arbitrary geometry in a way the is relatively even.

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .