0
$\begingroup$

Im trying to make a simple shelf but it doesnt want to UV Unwrap properly, and i dont know what im doing wrong.

Here is an image of the faces that doesnt want to work, as you can see the dot indicating where the middle of the face is is to the side on the selected ones, not in the middle. Faces that doesnt want to unwrap properly

At first i thought maybe filling in these would help, but it doesnt Filling these holes doesnt help

This is how the unwrap looks

This is how the unwrap looks

What am i doing wrong?

Improve this question
$\endgroup$
0

1 Answer 1

Reset to default
2
$\begingroup$

It looks like all four of your faces have more than four vertices, perhaps because of duplicate vertices. Do eliminate these, in edit mode, press "W > remove doubles". If this is not it, then it's likely that the four faces marked for unwrapping are n-gons. The likelihood is that the faces with the off center face selection dots are the offenders.

Improve this answer
$\endgroup$
1
  • $\begingroup$ I tried removing doubles, didnt work. Edit: The problem was more than 4 verts, if i select the top 2 and bottom 2 anf then fill the gap the UV works, thanks :) $\endgroup$
    – qwertyqywterqwerty
    May 10, 2017 at 10:24

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .