0
$\begingroup$

I want my mesh to connect so I attempted Intersect (Knife). As you can see these edges are not connected, I pulled it away for the picture so you can see the topology.

enter image description here

So I selected these faces and used Intersect (Knife)...

enter image description here

Then it looks like there was added vertices. However if the vertex is grabbed and pulled away, you will see that only one of the faces, meaning that I can't merge doubles because the other face doesn't have any vertices added from this operation.

enter image description here

$\endgroup$
  • $\begingroup$ Intersect works well of clearly intersecting geometry, not coplanar tangentially grazing barely touching edges. $\endgroup$ – Duarte Farrajota Ramos May 8 '17 at 21:06
  • $\begingroup$ Then how to merge them? $\endgroup$ – Accumulator May 8 '17 at 21:21
  • $\begingroup$ Lots of ways. Off the top of my head, erase the big face and extrude the three edges to the side until the fill the remaining gap. $\endgroup$ – Duarte Farrajota Ramos May 8 '17 at 21:43

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.