11
$\begingroup$

How can I divide a circle into a square grid? Think of the subdivision of a plane, but with a circular border. It should look something like this, just imagine that the circle select cursor is the border:

enter image description here

I searched everywhere for an answer, but I could not find any. Any help will be appreciated!

$\endgroup$
16
$\begingroup$

This is how I do it: gridify circle

  1. Create a circle and put it a little over the grid plane;
  2. In Object mode select the circle first, then add the plane to the selection, by pressing ⇧ ShiftRMB RMB (the order is important);
  3. Go to top view (Numpad 7) in Orthographic View (toggle with Numpad 5);
  4. Go in Edit mode with ↹ Tab;
  5. Be sure to have all the meshes selected (hit A);
  6. In the T panel (or just by searching with Space) find Knife project and click it.
  7. Invert the selection with Ctrl+I
  8. Delete the selected mesh parts with X.

Like LukeD said in another answer, this causes your mesh to have a mix of ngons, quads and tris, but that's what you asked for in your question. :-)

$\endgroup$
  • $\begingroup$ This looks like the answer I'm looking for. I'll try it. $\endgroup$ – Tooniis Jan 23 '17 at 19:16
  • $\begingroup$ Also I don't care about the ngons and tris in the edges because I'm not going to modify them. I'm only going to modify the quads. $\endgroup$ – Tooniis Jan 23 '17 at 19:17
0
$\begingroup$

You can do with the F2 Addon Select 2 vertex and press f to make a edge Then Press F to make vertical edges same with the horizontal edges enter image description here

$\endgroup$
  • 1
    $\begingroup$ Why did you double my answer? $\endgroup$ – cgslav Jan 23 '17 at 12:39
  • $\begingroup$ actually i answered and did not refresh somebody answered it after refresh my answer was below yours sorry $\endgroup$ – atek Jan 23 '17 at 12:44
  • 5
    $\begingroup$ The results don't look at all the same. $\endgroup$ – StarWeaver Jan 23 '17 at 13:00
  • 1
    $\begingroup$ Despite the final result looks like a grid, the horizontal and vertical edges built with this approach are disjoined: you are building two overlapping sets of faces. Perhaps it would be better to finish with Vertex Connect Path tool or something in order to truly subdivide the edges. $\endgroup$ – Carlo Jan 23 '17 at 18:04
  • 2
    $\begingroup$ I did that with the knife but soon realised that it is not a perfect square grid. $\endgroup$ – Tooniis Jan 23 '17 at 19:16

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.