1
$\begingroup$

So I made a simple camera rig (camera clamped to nurbus circle and parented to an empty, dead center in middle) but I get this unwanted jitter, not sure what causes it, if someone knows solution, I would be grateful, thanks!

Problem shown in a Youtube video attached

Youtube Link

$\endgroup$
0
$\begingroup$

Sounds like there is a conflict, two constraints fighting for control of the camera - the path and the empty. To avoid this, have an empty follow the path, and parent the cam to the empty. This will allow independent use of the cam, i.e. 'look at', rotation, etc.

I've used an invisible cube here to illustrate.

| improve this answer | |
$\endgroup$
  • $\begingroup$ Thanks so much for your troubleshooting, yea I think I might used like two constraints and they were conflicting together or the circle resolution I was using was way too low. $\endgroup$ – TmkDigital Jan 17 '17 at 16:22

Not the answer you're looking for? Browse other questions tagged or ask your own question.