2
$\begingroup$

I would like a small help with an issue that occurs while I try to enter Sculpt mode.
I don't use Dyntopo (don't want to add more faces to my mesh that I have nor to break and add new. I am working with what I have and just wish to "reorganise" them a little bit).
Sadly, I can only add to my mesh, but I can't use subtracting brush effect. The Ctrl doesn't work (opposite to what I am doing) and I can't even find the add/subtract option in my tool panel. What am I missing here? Could someone advice me what to do so that I don't use always Ctrl+Z and do it over until I reach my desired form?

I am new to sculpting, I have watched some tutorials but I just can't find the add/subtract nowhere in "normal"(?) sculpting mode (again, not in dyntopo!).

Thank you in advance.

EDIT: found my problem, it looks like that the F smooth doesn't have an add/subtract option. I just want to smooth a little bit out and then work around that. Sorry for the waste of space.

Improve this question
$\endgroup$
1
  • 1
    $\begingroup$ While using another brush, hold 'shift' to smooth $\endgroup$
    – lemon
    Jul 28, 2016 at 11:22

1 Answer 1

Reset to default
1
$\begingroup$

Found my problem, it looks like that the "F smooth" doesn't have an add/subtract option. I just want to smooth a little bit out and then work around that. Sorry for the waste of space. Perhaps the option "add/subtract" might be welcome for this option also.

Improve this answer
$\endgroup$
2
  • $\begingroup$ You can really spped up workflow by holding Shift to use Smooth brush. Not sure what the reason for it to have Subtract effect; to deepen strokes, use Deepen brush, to flatten - use flattening brushes. Smooth uses smoothing in general so there might not be any opposite effect to it. $\endgroup$
    – Mr Zak
    Jul 29, 2016 at 14:14
  • $\begingroup$ You aren't wasting space. The point of SE is that someone else might have had this question as well. If you think your answer is the best answer, you can accept it BTW. $\endgroup$
    – 10 Replies
    Jan 2, 2017 at 22:55

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.