1
$\begingroup$

If I do the following:

  • Add a NURBS curve
  • Select a control point
  • Press N and change its y property to 0.0
  • Repeat this step for all the control points of the NURBS curve

Then I'm unable to edit the single control point: if I select a single control point and try to move it, the whole NURBS curve with all the control points are displaced. It seems like the curve becomes a whole object whose single points cannot be modified. If instead I just change the x,y,z values of the single control points through the panel they are edited singularly.

$\endgroup$
5
  • $\begingroup$ Can you give us a screenshot? An animated GIF would be even better. $\endgroup$
    – Matt
    May 26 '16 at 20:16
  • 1
    $\begingroup$ Did you by accident press the O key and turn on proportional editing? Try disabling it in the 3D view toolbar at the bottom of the screen $\endgroup$ May 26 '16 at 20:18
  • $\begingroup$ Yes, I had proportional editing turned on. Thank you for the answer. $\endgroup$ May 26 '16 at 20:22
  • $\begingroup$ Hey @DuarteFarrajotaRamos... that'd make a pretty nice answer. Better get that posted before someone else does ;-) $\endgroup$
    – Matt
    May 26 '16 at 20:52
  • $\begingroup$ Hehe I didn't deem it was worthy of a full answer for such a common and small problem, but I'll post it bellow. Thanks $\endgroup$ May 26 '16 at 22:52
2
$\begingroup$

Sounds like you unintentionally pressed O key by accident and turned on Proportional editing.

Try disabling it in the 3D view toolbar at the bottom of the screen

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.