2
$\begingroup$

I have been modeling and then I've noticed that I had a strange seam going at a certain part of my mesh, quite weird, can't figure out what is causing this to happend.

enter image description here

enter image description here

enter image description here

Improve this question
$\endgroup$
1
  • 2
    $\begingroup$ Looks like you have N-gon face that cause this error $\endgroup$
    – Denis
    Sep 3, 2015 at 18:53

1 Answer 1

Reset to default
2
$\begingroup$

Extend those vertical edge-loops all the way through those three bottom horizontally-aligned faces (the top of those three clearly being an n-gon, not sure of the two below it). This should go a long way toward fixing your problem.

Improve this answer
$\endgroup$
2
  • $\begingroup$ Is there a way I can extend the loopcuts without using the knife tool?? as it is going to take ages with it. $\endgroup$
    – A.D.
    Sep 3, 2015 at 19:27
  • 1
    $\begingroup$ You could use Ctrl+R on the bottom two faces, then roll the mouse wheel until you get the 9 or more cuts you need, then use Ctrl+E -> 'Edge Slide' on the edges to align them to existing edge loops above. $\endgroup$
    – Mike Metcalf
    Sep 3, 2015 at 19:35

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .