5
$\begingroup$

I was naming bones while rigging my model. While typing a bone name I saw my model move upwards without my knowing command. I eventually found it from a speck in the far distance. I scrolled it in successfully. But now it fails to respond to "View" commands. If I hit "7" for aerial view it disappears....again I find it as a speck and scroll it in. This happens with all "view" commands...

When I do locate it and try to drag it around it is as if there is a pivot point miles away and the slightest grab and drag sends it into oblivion.

My pivot point is set on default and my manipulator is set to Global. My model stays in the correct position on the grid all the time.

Any suggestions would be greatly appreciated.

Improve this question
$\endgroup$
0

1 Answer 1

Reset to default
5
$\begingroup$

try to select your model and press the period key on your numpad

Improve this answer
$\endgroup$
2
  • 1
    $\begingroup$ I'm on a laptop but the period key did seem to work. Thanks for the help. $\endgroup$
    – Gavia
    Aug 4, 2015 at 21:11
  • $\begingroup$ Could you mark it as the best answer if it was helpful $\endgroup$
    – A.D.
    Aug 5, 2015 at 16:32

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.