22
$\begingroup$

I had trouble merging/dissolve two faces together, like merging these two faces in the screenshot. Any help is appreciated :)

enter image description here

enter image description here

|improve this question
$\endgroup$
  • $\begingroup$ could you upload your blendfile? $\endgroup$ – gladys Jul 25 '15 at 7:27
  • $\begingroup$ if F and Limited dissolve don't work you might want to share the .blend because I think you might have some unusual (accidental) geometry you aren't aware of. $\endgroup$ – zeffii Jul 25 '15 at 7:27
  • 1
    $\begingroup$ @Mr.Benson to mark it as solved you have to accept the right answer using the check mark on the left of the answer ( not by writing solved ) $\endgroup$ – Chebhou Jul 25 '15 at 8:24
24
$\begingroup$

I think what you're looking for is the F key, this joins any selected faces if it makes sense topologically.

enter image description here

But, you will get an Ngon on that face.

|improve this answer
$\endgroup$
  • $\begingroup$ That worked. Thank you so much for your help. :) $\endgroup$ – Mr.Benson Jul 25 '15 at 8:22
15
$\begingroup$
  • Go to edge select in edit mode (Ctrl +Tab --> EDGE),
  • select the middle edge of the two faces.
  • Then X --> dissolve edges
|improve this answer
$\endgroup$
  • 2
    $\begingroup$ you do not have to be in edge mode for that to work, just select the middle face, then "dissolve edges" $\endgroup$ – David♦ Jul 24 '15 at 19:44
  • $\begingroup$ The object became corrupted like the second screenshot after I dissolved the middle edge. $\endgroup$ – Mr.Benson Jul 25 '15 at 5:54

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.