3
$\begingroup$

I'm going to go ahead and do it manually, but before I do I would like to know if there is a better way

$\endgroup$
3
  • $\begingroup$ Did you try the thickness setting on the modifier? $\endgroup$
    – J Sargent
    Jul 11, 2015 at 18:06
  • $\begingroup$ Delete inside faces and either redo the solidify modifier, or use the solidify edit mode operator? $\endgroup$ Jul 11, 2015 at 18:13
  • 2
    $\begingroup$ If the mesh isn't that complex it may work using scaling along normals (Alt+S) with Even thickness turned on of faces created by modifier $\endgroup$
    – Mr Zak
    Jul 11, 2015 at 18:47

1 Answer 1

1
$\begingroup$

There is a way in edit mode you might prefer if you select the wall faces and press Ctrl F and choose Solidify. The thickness appears in the operator on the left. The new faces are automatically highlighted so at that point, you can add the new faces to a new group. Then if you make further modifications and want the thickness different you can select the faces from the group, delete and redo.

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .