0
$\begingroup$

I'm following Blender Guru's chair tutorial and have arrived at a state where upon extruding, the mirroring of the mesh "disconnects". I've been working left-to-right here. I was mirroring the two halves by hand. Then I deleted one half of the mesh, and just mirrored it. After, I tried extruding the back face of the mesh and have this weird behavior.

enter image description here

enter image description here

Improve this question
$\endgroup$
1
  • 2
    $\begingroup$ Are you sure that there are no faces between the two part being mirrored? $\endgroup$
    – The Kalaakaar
    Commented Sep 2, 2023 at 12:12

1 Answer 1

Reset to default
0
$\begingroup$

Thank you @the-kalaakaar There were indeed faces, as shown below. Removing them fixed the problem. As a follow-up, how can I make sure to not create these faces when extruding?

enter image description here

Improve this answer
$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .