1
$\begingroup$

I've been trying to make an even continuation of a pattern that's on the top part of a mesh lower on the side faces, but pattern keeps stretching to the inside. Any ideas how to make the stipes that are marked as red go straight down like green lines?

example below example below

Improve this question
$\endgroup$
2
  • 1
    $\begingroup$ For a simple stripe texture you could try the following. Top orthographic view > U > Project From View. Then in the UV editor, select all and scale up the UV's as required. $\endgroup$
    – 3fingeredfrog
    Aug 4 at 17:05
  • $\begingroup$ @3fingeredfrog You should propose that as an answer $\endgroup$
    – moonboots
    Aug 4 at 18:35

1 Answer 1

Reset to default
1
$\begingroup$

Try the following:

  1. In Top Orthographic view (7), Edit mode with all selected > U > Project from View.
  2. In the UV editor, scale and position the UV's as required.

enter image description here

Improve this answer
$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .