1
$\begingroup$

I want to wrap the top part of the banner (red) onto the horizontal cylinder of the pole and then use the wind physics for the rest of the banner. How I can wrap only the top part? I have divided the surface but shrinkwrap does not gives me the result I need. Thanks in advance.enter image description here

$\endgroup$
5
  • 1
    $\begingroup$ Have you tried shrinkwrap using a vertex group applied to the top of the flag? $\endgroup$
    – Callmepro
    Mar 20 at 15:29
  • 1
    $\begingroup$ You'll need to subdivide the top part horizontally. A few loop cuts or knife cuts in edit mode should do the trick. A mesh can only bend as much as its geometry allows it to. You can also use the spin tool $\endgroup$
    – Gorgious
    Mar 20 at 16:18
  • $\begingroup$ Hello could you please make a drawing of how it is supposed to wrap onto the cylinder? $\endgroup$
    – moonboots
    Mar 20 at 16:32
  • $\begingroup$ !Banner help $\endgroup$
    – Morfeas333
    Mar 20 at 16:54
  • $\begingroup$ The easiest way if you make loop cuts on the rod, duplicate tha part where the flag is, upscale them, delete the face near the flag and bridge them together. $\endgroup$
    – FFeller
    Mar 20 at 17:59

1 Answer 1

2
$\begingroup$

you can use a simple deform modifier, if you have this topology (create some loop cuts):

enter image description here

and assign the selected vertices to a group:

enter image description here

and use the simple deform modifier like this:

enter image description here

result:

enter image description here

$\endgroup$
2
  • $\begingroup$ Thanks! I did manage to end to this solution by myself. I did not used the correct start for the loop initially. $\endgroup$
    – Morfeas333
    Mar 21 at 16:23
  • $\begingroup$ @Morfeas333: If my answer helped you, pls click on the checkmark left of my answer. thx. $\endgroup$
    – Chris
    Mar 21 at 16:33

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .