3
$\begingroup$

I am working on the mesh that I'm trying to bend 250 degrees around itself.

front view

top view

I tried using simple deform modifier but as a result I keep on getting following result.

top view after applying the bend

What should I do in order to 'block' or make all the lines follow the bend so that when looking from the top view none of the line would surpass?

Improve this question
$\endgroup$
3
  • $\begingroup$ Add a sub div modifier. Let me know how it works $\endgroup$
    – J Sargent
    Commented Apr 12, 2015 at 11:16
  • 3
    $\begingroup$ Or select the interior edges and subdivide them, subdiv modifier might give you some undesirable geometry $\endgroup$
    – zeffii
    Commented Apr 12, 2015 at 11:38
  • $\begingroup$ Thank you very much for the answers. Finally the problem was in the basic construction of the mesh. I added the loop cuts to each of the lines and now I can bend it easily using the Simple deform modifier. $\endgroup$
    – maria
    Commented Apr 12, 2015 at 12:04

1 Answer 1

Reset to default
3
$\begingroup$

The problem was in the construction of the mesh. I added loop cuts to each of the lines and then bended it using the simple deform modifier.

Final view from the front

Final result

Final view from the top

Improve this answer
$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .