-2
$\begingroup$

enter image description here

enter image description here

enter image description here

Theres this weird thing happening here. Ive tried to merge all vertices, I can't see any mesh under it, Ive tried to grab and pull it around but I always have this weird highlighted line here.

$\endgroup$
6
  • $\begingroup$ seems like a pinch where a vertex or an edge was extruded inside the mesh? $\endgroup$ Commented Jan 9, 2023 at 21:14
  • $\begingroup$ How would I be able to figure that out? $\endgroup$ Commented Jan 9, 2023 at 21:16
  • $\begingroup$ Look at the object in Xray view, and then Select -> Select all by trait -> Non-manifold should give some hint $\endgroup$ Commented Jan 9, 2023 at 21:16
  • $\begingroup$ A few diagnostic routines.. H hide a few faces and look inside... jiggle some vertices to check for doubles, in 'Overlays', switch on 'Face Orientation' to check for inverted normals.. $\endgroup$
    – Robin Betts
    Commented Jan 9, 2023 at 21:23
  • $\begingroup$ If it helps I extruded new vertacies to make some quads and it looks like there's an edge but without a selectable edge. Hope that makes sense $\endgroup$ Commented Jan 9, 2023 at 21:30

1 Answer 1

1
$\begingroup$

I fixed it. One of the edges wasnt connected to the face. I deleted the face underneath and created new faces

$\endgroup$
1
  • $\begingroup$ The 3D Print add-on is a helpful tool for these sorts of problems. It can show you intersecting faces and non-manifold edges (open edges that would make a hole where “water” would spill out of making the object not “water-tight”). $\endgroup$
    – Leo Aguiar
    Commented Jan 10, 2023 at 2:32

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .