1
$\begingroup$

This is the result I am getting from this image shrinkwrapped to the mug. The image has 200 loop cuts. I have tried other settings, such as project but most of them do absolutely nothing to the image. enter image description here

image I have attached

UPDATE: If you look at the mug from the side you will see that the center markings on the road image are at different sizes. They are random sizes. Though they are gathering up and getting smaller as they go around the cylinder. None of the loop cuts are evenly distributed either. enter image description here

$\endgroup$
2
  • $\begingroup$ From what I can see, it looks pretty much shrinkwraped on the screenshot. Perhaps you might need to send a screenshot with a more relevant angle $\endgroup$
    – Alex
    Nov 24, 2022 at 23:30
  • $\begingroup$ @Alex I have amended the images to show a side view. Here you can see than randomness of the loop cuts when the shrinkwrap is applied and the affect it has on center lines which are all different sizes. $\endgroup$ Nov 25, 2022 at 4:47

1 Answer 1

1
$\begingroup$

Try to change the wrap method to target normal project, it usually gives a better projection as you can see in these pictures

enter image description here

enter image description here

Also make sure the mug has enough resolution, the higher it is the more acurate the projection will be (it needs to have more resolution than the projected mesh)

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .