0
$\begingroup$

There used to be the Stable ID socket on the Distribute Points On Faces node. Where did it go? My instances are "jumping".

The manual says to use the ID > Set ID Nodes, but I cannot figure out where to initiate them in my nodeflow. Can you please elaborate on that?

$\endgroup$
1
  • $\begingroup$ can u show us your node tree or provide blend file? $\endgroup$
    – Chris
    Dec 7, 2021 at 15:51

1 Answer 1

0
$\begingroup$

Sorry for the delay, of course here is the nodetree. It's an example of dynamic proximity scaling.

SOLUTION: The problem was caused by the RGB Curves node - the clamping was too harsh so it caused the sudden jump in size.

here´s the Nodetree. hope that helps.

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .