This is my first ever Blender Stack exchange post. I am trying to use fSpy to recreate an interior. However, whenever I extrude the plane which I'm to align with the floor, it seems that extra loop cuts are made for every extrusion. I've tried extruding in vertex, edge, and face mode but this problem is still persisting. I've also tried selecting the extra loop cuts individual and deleting the edges. However, when I do this it ends up deleting some of the plane. I am trying to extrude the plane in such a way that no extra loop cuts will be made. Any tips would be much appreciated.


  • 3
    $\begingroup$ The extra "loop cuts" are normal when you extrude an edge. An extrusion extends the edge without removing the original edge, hence it's no "loop cut" because a cut adds edges where no edges were before. If you don't want those extra edges, you should simply move them with G instead of extruding. Or if you want to get rid of them, instead of deleting an edge you should dissolve the edge. So hit X > Delete > Dissolve Edges instead of X > Delete > Edges. $\endgroup$ Commented Nov 2, 2021 at 7:45
  • $\begingroup$ You can just use CTRL-X to dissolve edges or vertices rather than having to go through a menu. $\endgroup$
    – John Eason
    Commented Nov 2, 2021 at 9:33

1 Answer 1


If you want to extend your plane without adding any extra edge loops it can be done by either moving it on the desired axis by pressing 'G' and then pressing the desired axis (eg. 'GX') or scaling the mesh by pressing 'S' and then pressing the desired axis. (eg. 'SX').


enter image description here


enter image description here

  • 1
    $\begingroup$ "At the same time" sounds like you have to press both keys at once, but you can simply hit the key for the axis after hitting G for moving or S for scaling. And for the sake of completeness, if you want to move or scale in all directions except for e.g. the Z axis, you can press Shift + Z to constrain the action to X and Y. $\endgroup$ Commented Nov 2, 2021 at 8:43
  • $\begingroup$ oops sorry for that :( the answer is updated.Thanks, Gordon :) $\endgroup$
    – Ribbit12
    Commented Nov 2, 2021 at 8:54

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .