1
$\begingroup$

I have a shape that I made out of extruding a circle a few times and adjusting the size of the edges.

I'd like to make it so that the highlighted edges form a smooth ramp, but I'm not sure how to do this. I've tried bevels, but it's beveling the vertical edges only, without making any kind of curve

enter image description here

This is roughly the shape I'd like to achieve

enter image description here

What are some ways of accomplishing this?

$\endgroup$
0
2
$\begingroup$

You could create this shape:

enter image description here

Then bevel the bottom edge, tweak the parameters in the Operator box so that it follows the curve with the amount of segments you want:

enter image description here

Or just create this cylinder shape, create horizontal edge loops:

enter image description here

then scale the edge loops so that it fits the shape, create additional ones:

enter image description here

$\endgroup$
2
  • 1
    $\begingroup$ If you use Proportional Edit set to Sphere, you can select an edge loop just above the centre and scale with SHIFT-Z to create the curve. $\endgroup$
    – John Eason
    Aug 22 at 18:33
  • $\begingroup$ @John Eason oh ok I haven't tried $\endgroup$
    – moonboots
    Aug 22 at 18:41

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.