1
$\begingroup$

In Edit Mode, when I use Loop Cut (CTRL+R) to cut cube at half, when I remove one of the sides, it results into the following:

Half

The problem is that one face is missing. I tried Sculpt Mode and Grab tool doesn't do it correctly. I did try pressing V according to youtu.be, but it's sticking what exists instead of recovering the cut vertices of the missing face.

Also, I could try creating new cubes, but it'd be in pratice easier to split the existing one, according to the video I mentioned.

$\endgroup$

1 Answer 1

2
$\begingroup$

That is the expected behavior. Select the 4 vertices that surround where the missing face would go and enter F to create the face.

Before:

half cube

After:

half cube with new face

$\endgroup$

You must log in to answer this question.