3
$\begingroup$

I want align these edges in single even RED line? enter image description here

enter image description here

$\endgroup$
1
  • 2
    $\begingroup$ Assuming that's an overhead view (numpad 7), with those faces selected, type 'Sz0' ENTER (Scale Z zero). $\endgroup$
    – John Eason
    Jun 28, 2021 at 11:38

1 Answer 1

6
$\begingroup$

If the red line is perpendicular to the X axis, just press SX0 as suggested by John Eason.

If your red line is parallel to the first face, and this face is not perpendicular to X, you can first push the other faces:

enter image description here

enter image description here

Then in top view use the Knife tool, K to activate, Z to cut through, make sure it snaps to the 2 vertices of the edge so that it follows its direction:

enter image description here

$\endgroup$
4
  • 2
    $\begingroup$ Well. I never... New one on me. 'The point that Knife would have snapped to, if I clicked there', just using the highlight. Great time-saver. $\endgroup$
    – Robin Betts
    Jun 28, 2021 at 11:56
  • 1
    $\begingroup$ I didn't remember that actually, I just tested $\endgroup$
    – moonboots
    Jun 28, 2021 at 11:59
  • $\begingroup$ Holy hell. How long has that feature been there? I don't use knife that often, but this is game changing. Great find! $\endgroup$ Jun 28, 2021 at 12:26
  • $\begingroup$ knife is super useful! Seems like this feature was here in 2.7 $\endgroup$
    – moonboots
    Jun 28, 2021 at 12:40

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .