I would like some feedback on a model of the frypan I’ve made recently.
I think I have a serious problem with the tip of the handle. It looks wonky, and the edges that form it are too sharp (I’ve added some examples below). Adding some geometry manually doesn’t make much of a difference at the current moment.
When modeling the handle, I took the next approach: 1) I extruded the mesh according to the reference. 2) Then, to make the widest part of the handle, I used the proportional editing on the bottom vertices. 3) After that I added some loopcuts to the side of the handle and edited mesh manually to match rhe reference. Now I’m not sure If I did something wrong or if it was the wrong approach.
Any help would be greatly appreciated. Thanks in advance.