0
$\begingroup$

I'm modeling a microwave and I'm stuck with making this little notches, which I highlighted in the reference picture. I tried to perform a boolean operation, but it didn't work out and I don't know why. I'm not sure if this was a good approach though. Just deleting faces doesn't work too because of subdiv.

Any help is appreciated! enter image description here enter image description here

$\endgroup$
4
  • $\begingroup$ Does this help you? blender.stackexchange.com/q/214144/107598 $\endgroup$ – Blunder Jun 17 at 0:47
  • $\begingroup$ What do you mean by "Just deleting faces doesn't work too because of subdiv", if you extrude inwards then add a bit of topology to sharpen the edges it should work fine $\endgroup$ – moonboots Jun 17 at 6:42
  • $\begingroup$ @Blunder thanks, I think this will help! $\endgroup$ – jane_miller Jun 18 at 14:58
  • $\begingroup$ @moonboots thank you, I'll try it! $\endgroup$ – jane_miller Jun 18 at 14:59

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.