I'm modelling the bridge of a spaceship and I want it to look as if it was engineered. How would I make sure all these cuts are equal? I just loop cut it and eyeballed it (3 on the front, 4 on the side) but I am also concerned about the diagonals. Is there any way to cut around a mesh in equal parts?


  • $\begingroup$ You could use Knife Cut with cut-through activated (I've used this to cut-and-separate models along equally-spaced cubes before, for example); if the non-diagonals are aligned with the y- and x-axes, this would give you everything but the diagonals, and it would give you enough vertices to form the diagonals by deleting faces/adding new faces back again. $\endgroup$ Feb 20 '21 at 2:57
  • 2
    $\begingroup$ Are you asking how to make equal diagonals (@JachymMichal) or all segments marked by yellow line? $\endgroup$
    – vklidu
    Feb 20 '21 at 8:46

You can use the Bevel modifier

  1. Select the edges where you want the cuts
  2. Add a Mean Bevel Weight through Sidebar
  3. Add a Bevel modifier, Limit method > Weight

Then just apply the modifier (if you want) and add loopcuts manually.

enter image description here


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.