1
$\begingroup$

I'm following a lesson of what I think was made in ver. 2.8 and I'm currently using 2.9. As you can see in the image below (mine | lesson), in the lesson part the ColorRamp and Transparent BSDF are connected in the same shader socket in the Mix Shader and mine is not connecting both, when I try it just disconnect the other... Is there any node I can add to make it work?

enter image description here

$\endgroup$
4
  • 4
    $\begingroup$ The ColorRamp in the tutorial image is connected to the Mix Factor (fac), not one of the input sockets. You can tell because it replaces the Value slider. Just a bad angle on the connection makes it look like it's connected elsewhere. Connect your ColorRamp to the grey dot and you're good to go. $\endgroup$ Feb 18, 2021 at 3:10
  • $\begingroup$ Oh, my bad, I'm still learning and afraid of messing with anything I don't know, but also and my eyes are not that good and haven't noticed that hahah thank you so much! $\endgroup$
    – Stef
    Feb 18, 2021 at 3:16
  • 2
    $\begingroup$ Don't be afraid, that's what the undo button is for! $\endgroup$ Feb 18, 2021 at 4:07
  • 1

0

You must log in to answer this question.

Browse other questions tagged .