1
$\begingroup$

I am currently trying to render out an image sequence that I imported into Blender's compositor and put a denoise node to. I set the start frame to 1 and the correct amount of frame length and offset. When I render the animation, it re-renders over the original image sequence which is fine, but it only renders the last frame of the sequence over each image. I then have to re-render the image sequence since it basically replaced my image sequence with a single image. Does anyone know how to help?

Here are my compositor settings: enter image description here

The offset is set to 116 because thats when the image sequence and animation begin.

Improve this question
$\endgroup$
7
  • 1
    $\begingroup$ Why do you have the offset to 116? $\endgroup$
    – susu
    Feb 8, 2021 at 4:42
  • $\begingroup$ Because thats where my animation begins. $\endgroup$
    – Ryan Nyberg
    Feb 8, 2021 at 4:43
  • $\begingroup$ So my original image sequence I rendered was frames 117-130, I then imported that image sequence into the compositor and added a denoise node. I want to rerender those frames using the denoise node and the compositor $\endgroup$
    – Ryan Nyberg
    Feb 8, 2021 at 4:46
  • $\begingroup$ How did you set the frame range to be rendered in the output settings? $\endgroup$
    – susu
    Feb 8, 2021 at 17:26
  • $\begingroup$ I'm not sure what you mean, I have the timeline set to the specified 14 frames I want rendered... $\endgroup$
    – Ryan Nyberg
    Feb 8, 2021 at 17:30

1 Answer 1

Reset to default
4
$\begingroup$

The error is this you are setting the offset to 116, but the start frame is set to 1, so the 14 frames you want to render would be rendered in frames 1 to 14. Otherwise you are getting a repeat of the last frame.

enter image description here

On a side note, it is quite unfortunate that you chose to use png as image format, by doing so you've lost a lot of the information that would help you denoise the image. In the future use EXR mulilayer and save the denoise passes.

Improve this answer
$\endgroup$
1

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .