2
$\begingroup$

After extruding one time or subdividing the curve, if I try to extrude again, I get a figure 8 loop. I've used bezier curves before, but this is the first time in 2.9. Anyone know how to work around this?

enter image description here

$\endgroup$
3
$\begingroup$

This type of extrusion actually splits this control point and adds a new one in the middle.

enter image description here

It's not obvious that it happens since they are in the same location.

$\endgroup$
2
  • $\begingroup$ Wooowwww I didn't know what you meant at first, but after clicking around I see it. WTH? Maybe I'm just a noob, but I don't think that's not very intuitive. $\endgroup$ Feb 6 '21 at 1:46
  • 1
    $\begingroup$ if you want a branch I think you can duplicate a control point and right click to send it back to original position, then you can extrude it basically starting a new curve $\endgroup$ Feb 7 '21 at 8:44

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.