0
$\begingroup$

I was making low-poly Audi A6 C6 avant. So i made almost everything but I have a problem. When I try to make the last wall of the roof, a problem arises. One of the edges spoils the whole look. I use the Subdivision Surface but even when it turns it off, the error still shows up. Please helpenter image description here

enter image description here

It's not even helping when using "Shade Flat". And yes, I enabled AutoSmooth to 30*

$\endgroup$
5
  • $\begingroup$ Could you post an image of your object in edit mode without the SS modifier so we can see the topology? It's likely just a duped or unmerged edge or possibly a slight upward "kink" in the mesh surface. Either way, its hard to tell without seeing the edge lines. $\endgroup$ Jan 27, 2021 at 16:23
  • $\begingroup$ pasteboard.co/JLBrYiH.png here you are $\endgroup$ Jan 27, 2021 at 16:43
  • $\begingroup$ Still nothing. When I'm trying to fill the empty face it creates a weird edge, that is sharp... Sorry for my bad english. $\endgroup$ Jan 27, 2021 at 17:47
  • $\begingroup$ Yeah, not sure then. have you tried removing all dupes (Select all in edit mode, then mesh > Clean up > Merge by distance) and making sure the normals are all facing the right way (mesh > normals > recalculate outside)? $\endgroup$ Jan 27, 2021 at 18:11
  • $\begingroup$ Yeah, thank you :DDDDD Some faces were inverted, so it was looking weird. Once again, thank you :) $\endgroup$ Jan 27, 2021 at 18:47

0

Browse other questions tagged .