0
$\begingroup$

I saw a tutorial about Procedural Noise texture, but I want to add an image on the surface of the texture. I set up the Nodes but cant figure the correct order to get my image showing.

Thank you.

enter image description here

$\endgroup$
2
  • 3
    $\begingroup$ you need to plug the Bump in the Normal socket of the Principled, I guess that's what you want to do... $\endgroup$
    – moonboots
    Jul 11, 2020 at 15:43
  • $\begingroup$ Thanks heaps for that, it was exactly what I was after.I needed to manipulate the settings of the bump strength to get the image to show trough, because the higher the strength the image was getting buried into the mesh. ibb.co/pwSn7kK Kind regards. $\endgroup$ Jul 12, 2020 at 6:53

1 Answer 1

0
$\begingroup$

You need to plug the Bump node in the Normal socket of the Principled BSDF.

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .