0
$\begingroup$

the glass is acting odd enter image description here the faces are oriented the right way enter image description here so i thought it was because of the odd geometry enter image description here and i dissolved those enter image description here so im stuck can someone help me

Improve this question
$\endgroup$
1
  • $\begingroup$ try increasing the mean crease or adding edge loop $\endgroup$
    – JacksonPro
    Commented Jun 8, 2020 at 2:07

1 Answer 1

Reset to default
0
$\begingroup$

I would try clean up that topology around the bottom of the glass - rather than those stretched areas, delete those faces and try clean loops, it will help even out the subdivision surface. Use edge loops or Inset (I) as required. enter image description here

Improve this answer
$\endgroup$
1
  • $\begingroup$ with a little bit of fiddling it worked $\endgroup$
    – tyguy
    Commented Jun 9, 2020 at 0:15

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .