I have 2 closed segments made from bezier curves. ultimately these segments outline a surface i am trying to create. is there a way to join points between those 2 segments? then convert to mesh and create a surface
I would suggest that after creating your two paths, you convert each one to a mesh, then you Join Ctrl+J the two new meshes, then in Edit Mode you select segments of vertices on each side and make a new Face.
The reason you should select a small segment at the time is if you were to take the whole thing there is a risk that it creates one large face that can cover the hole in the middle. You can use the Circle select to grab a set of vertices.
Hope this works for you.