4
$\begingroup$

Referring to the attached image, using a simple extrude and scale workflow, is it possible to snap the upper extrusion so it matches the size of the lower one? I thought this would be quite simple but I just can't seem to work it out....

enter image description here

$\endgroup$
6
$\begingroup$

With the top face deleted and vertices selected ...

  • Set Pivot to Median
  • Set snap to Vertex and Active, and set it to influence Scale. Check 'Project on to Self'.
  • With cursor close to Active (white) vertex Extrude E Scale S Limited Axis ShiftZ and snap the active vertex to the one below it.

enter image description here

(Holding Ctrl while dragging toggles the 'Snap' state.)

$\endgroup$
  • $\begingroup$ Brilliant. Thank you so much ! That worked perfectly. $\endgroup$ – Marcus Feb 17 at 4:22

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.