0
$\begingroup$

I'm new to Blender and want to be able to precisely adjust bevel values for faces, edges, and vertices by entering numeric values. Is there any way to do this?

$\endgroup$
2
  • $\begingroup$ you talking about the bevel modifier or the bevel tool in edit mode? $\endgroup$
    – David
    Commented Aug 24, 2019 at 2:47
  • $\begingroup$ @David The bevel tool: "[I] want to be able to precisely adjust bevel values for faces, edges, and vertices..." $\endgroup$ Commented Aug 24, 2019 at 12:54

1 Answer 1

1
$\begingroup$

Just hit ctrl-B to bevel, and then you can set a number value for however much you want it to bevel. You probably would want to keep it under 1 to avoid the mesh overlapping itself, but it depends on the mesh.

$\endgroup$
4
  • $\begingroup$ hope that was what you wanted, and not what you already know. Where you talking about bevels that already existed? $\endgroup$
    – RBlong2us
    Commented Aug 24, 2019 at 0:25
  • $\begingroup$ This helped me figure it out! I just had to use ctrl+b and then click out of the auto-adjustment. Then I used the menu in the lower left corner. $\endgroup$ Commented Aug 24, 2019 at 0:36
  • $\begingroup$ You don't have to click out of the auto-adjustment. after hitting ctrl-B, you can type in the value and hit enter. That will give you the same result as typing in the value in the bevel menu. $\endgroup$
    – RBlong2us
    Commented Aug 24, 2019 at 0:44
  • $\begingroup$ If I misunderstood what you meant by auto-adjustment, feel free to correct me. $\endgroup$
    – RBlong2us
    Commented Aug 24, 2019 at 0:44

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .