I'm new to Blender and want to be able to precisely adjust bevel values for faces, edges, and vertices by entering numeric values. Is there any way to do this?
2
-
$\begingroup$ you talking about the bevel modifier or the bevel tool in edit mode? $\endgroup$– DavidAug 24, 2019 at 2:47
-
$\begingroup$ @David The bevel tool: "[I] want to be able to precisely adjust bevel values for faces, edges, and vertices..." $\endgroup$– Brendon ShawAug 24, 2019 at 12:54
Add a comment
|
1 Answer
$\begingroup$
$\endgroup$
4
Just hit ctrl-B to bevel, and then you can set a number value for however much you want it to bevel. You probably would want to keep it under 1 to avoid the mesh overlapping itself, but it depends on the mesh.
-
$\begingroup$ hope that was what you wanted, and not what you already know. Where you talking about bevels that already existed? $\endgroup$ Aug 24, 2019 at 0:25
-
$\begingroup$ This helped me figure it out! I just had to use ctrl+b and then click out of the auto-adjustment. Then I used the menu in the lower left corner. $\endgroup$ Aug 24, 2019 at 0:36
-
$\begingroup$ You don't have to click out of the auto-adjustment. after hitting ctrl-B, you can type in the value and hit enter. That will give you the same result as typing in the value in the bevel menu. $\endgroup$ Aug 24, 2019 at 0:44
-
$\begingroup$ If I misunderstood what you meant by auto-adjustment, feel free to correct me. $\endgroup$ Aug 24, 2019 at 0:44